How to Make: Wireless Leash

I made the wireless leash the reason why I made it is because as a animal owner myself I don't like to put my dog on a leash so I came up with an idea that will allow my animal to roam around but at the same time be able for me to control them so they don't go crazy

1. paper tape
2. duck tape
3. screwdriver
4. flat steel blade

next I found this Wireless heart monitor case it had two remotes in it and those are the two I took and then I grabbed one of the remotes and I started unscrewing it to grab the wire from it

Now, in Step 2, this is where I start taking it apart. First, I grab a screwdriver, and I start untying all the screws from it. Then I use the watch remover blade to remove the back cover. Then I proceed to open it up and take out the motherboard, place it down inside, and finally gain access to the antenna

In the third step, I took the antenna from the device that I took apart, and I attached it to a remote that I found, taping it together to represent the phone connected to the caller

I found an old electrical cord that will be the dog collar, with the other piece of the heart monitor where I taped up the cord first; then I proceeded to tape the heart monitor to the dog collar

now that everything is done this Google AI image is supposed to represent what it is supposed to look like and how it was supposed to work.

and now after everything is hooking apart and put together this is how you make a wireless leash.