Very Simple DIY Table Saw

by StephanP1 in Workshop > Tools

49705 Views, 171 Favorites, 0 Comments

Very Simple DIY Table Saw

This homemade table saw is made out of a track saw

The Idea

a track saw has a rail
but if you turn the saw upside down
the rail becomes a very handy cross cut sled

What Can You Expect?

with a special clamp , that fits into the rail
you have a very clever crosscut sled
you can cut every angle you want

and with a board, as a table saw fence, you can cut all of your stripes

for bigger parts, you can easily uninstall the saw
and use it as a normal track saw again

Overview

you need only to build

  • a jig for the deep setting,
  • a frame for the saw and
  • a trigger for the switch

How to Built the Frame

The frame is made out of two boards

in the first picture, you see a little nose on the saw

this nose disturb the fit of the boards

so I cut them out with a jig saw

Set Up

I screwed down one board on my table,
I placed the saw in position
and then I screwed down the second board

Secure the Saw

this saw has two holes on his plate

but unfortunately this holes are out of the range of the boards

so I screwed two blocks of plywood under the boards

and I could fix the saw with two screws

Prevent the Rail for Tillting

This rail has a second slot on the back

I used this to secure it in place

I drilled two holes, threaded them and screwed to bolts in

The Trigger

a little clamp, made out of 6 mm Plywood
hold the switch in place

for work with the saw you need an outlet with a switch

The Deep Adjustment, Step 1

My saw has a hole in the handle

in this hole fits perfect a 6 mm threaded rod

The Deep Adjustment, Step 2

this threaded rod goes through a slot of a little board

made out of 4 mm plywood

The Deep Adjustment, Step 3

to screw on this board, it was necessary to drill and thread a new hole

first I thought, I can use the existed hole above

but this is to high, and it disturbs the saw to tilt it to 45 degrees

Supporting Boards

my rail is 12 mm high

therefore I screwed two 6 mm boards of MDF on the left side

and two of them, glued together, on the right side

but on the right side, I made a cut with the saw so

the saw blade and the riving knife comes all the way through

The Result

Instead of thousand words, please watch the video

If you use a mobile device, use this link .

If you want to see more of my work, subscribe to my Youtube channel