Ultimate Workshop Stool

by ZombieWorkshop in Workshop > Workbenches

20551 Views, 426 Favorites, 0 Comments

Ultimate Workshop Stool

Well this is my Workshop stool made from a single 2x4 of 12 feet long

Wach the video

It has

  • Built in vise
  • BenchDogs
  • Magnetic strip
  • Extension support for mittersaw
  • Saddle Bag For tools and screws

It takes about 1 day to built and some scrap from my shop

i think the most difficult part is the end of the vise to make the ACME screw turn it taka about 2 hours to figure ot what i was doing XD

The aproximated cost of the project was $20 USD and some scrap pipe

Im glad to hear your comments

Sorry for the bad english it is not my native language.

The Vise

The vise have a 5/8 ACME Screw with a ACME screw coupler inserted by pressure into 3 layers of 3/4 inch plywood

The tubing on the sides of the screw prevent prom rolling the moving part theay are 5/8 diameter

The handle have a welded knob witha a hole to put the handle also a machined washer screwed to the wood this pull out the moving part when you untwist the screw

BenchDogs

The bench dogs are made form aluminium 1 inch on the superior part and 3/4 inch on the inferior part also I milled onse side flat to make the grip to the atached pice

Extension Support

This Extension suport is just one of the pieces of the top splited in hal and with 2 5/8 tubing

Saddle Bags

The saddle bag are made from scrap cloth

Enjoy

I always said ultimate in my projects , At least for me when I get out for ideas to adding atachments to my multitool creations