Typewriter Style IPad Stand

by NickZero in Design > 3D Design

173 Views, 0 Favorites, 0 Comments

Typewriter Style IPad Stand

This is a 3D printed iPad stand in the style of an old school type writer. It is designed for a 60% mechanical keyboard of around 100mm depth and 300mm width. It is made in several parts which bolt together using M2.5 screws. (8mm and 12mm)

Supplies

3D printer

PLA Filament - I have used black for the roller, Olive green for the body and Silver for the handles.

M2.5 8mm and 12mm countersunk screws

8x small self adhesive rubber feet

Printing the Parts

As above I printed the two halves of the roller in black, the body parts in Olive Green and the handles, spacer, spindles and feed handle in silver. You will need 2 spindles and 2 handles.

Everything was printed with 15% infill with supports where needed.

Assembly

  1. Screw the Left Side onto the Left Cross beam using 2x 12mm (Side) and 1x 8mm (back) screws.


  1. Do the same for the Right Side


  1. Fit the two halves of the roller together


  1. Now you can join the two halves with the front and rear join parts, while inserting the roller. You'll need 2x 8mm (outer holes) and 2x 12mm (inner holes) screws for the front and 4x 8mm for the back (longer 12mm would also fit here but sick out slightly underneath- the rubber feet will lift it off the table anyway)


  1. Now screw the spindles onto the handles using another 8mm screw (on the inner most hole)


  1. Put the spacer on one side and the Feed handle on the other side and slide both firmly onto the roller

Finishing Touches

Stick on the rubber feet to stop it from sliding around on the desk, fit your keyboard. The picture shows a cheap affordable "Newmen" GM610 wireless Bluetooth keyboard paired with my iPad.

The keyboard is needed for full stability - tilting it too far back without it means it will topple over.

The stand is best suited for Landscape operation - it will work portrait, but is a little less stable at extreme angles.

There is also provision for an "L" shaped USB-C adaptor in the middle of the roller if you have a tablet that has this on the landscape side.


Please let me know of this project and if the design could be improved in any way. 😊