Tube Breadboard

by BasinStreetDesign in Circuits > Electronics

8650 Views, 32 Favorites, 0 Comments

Tube Breadboard

Some time ago I built a bench power supply to be used with experimental tube circuits.  It was a very cool build experience and resulted in a flexible, powerful unit for supplying all of the various voltages needed with most tube projects as well as an instructable on it.  At the time, I didn't have a means of prototyping the actual circuit under test yet.  I needed a tube-appropriate breadboard.  I racked my brain (You know how painful it is to have a racked brain!) for months to think what could I do to make such a thing.  Well, at long last, here it is.

My instructable for the tube power supply can be found here:
https://www.instructables.com/id/Tube-Power-Supply/

Found Item

Firstly, the biggest problem in making a tube breadboard is to come up with a means of holding and connecting the various components used.  I vacillated between some kind of clip or spring terminal and soldered connections.  Then I was in a surplus electronic junk shop in London, ON called Electric & Electronic Supply Inc (www.elelsu.com).  If you are in the area I am sure they would appreciate a visit.  I found the item shown in the first photo.  It was perfect.  It just needed some of the stuff on it stripped off to have a good foundation for building new circuits.

But the best part of this found item was the neat spring clips it had.  I have looked all over but cannot find out who made/makes them.  They are used by pushing the top of them down to compress the spring and inserting the lead of a component through it.  There were about 85 of them on the board when I got it.  I took them all off as well as the rest of the connectors and chip sockets.

Board Construction

I am almost embarrassed to say that I did not build the breadboard.  It is quite simple:  a square foot or so of 1/8 inch thick perf board held off the bench by four pieces of 1/2 x 1/2 wood and small finishing nails.  It could be made in about 20 minutes if the parts were on hand.

Power Connectors

I put six five-way binding posts on the board to receive power from a power source: filament, B++, B+, C-, and Ground.  I put a .01 uf/400V cap from each of the B++, B+, C- to ground to take care of noise pickup from the power supply to the board.

Tube Sockets

The tube sockets used must be the variety which can be mounted with screws and stand-offs to the board.  Since my interest at this point was in a tube circuit that used only 7 and 9-pin miniature tubes I put one of each on the board.  Each pin of the sockets is wired to one of the spring clips.  Each spring clip is shoved through a hole in the board drilled between the existing 1/8” holes.  I used a 3/32” drill to make each clip hole and the clip just shoved in.  They sit tight enough in these holes to be robust enough to hold  most any component I may use.  But they are also not permanently fixed to the board.  They can be removed and put somewhere else as needed by the project at hand.

Use

Use of the breadboard is now straightforward.  I have built a small tube amplifier as shown in the last (and first) photo.