Trolley for Firewood Logs

by phico in Living > Organizing

3214 Views, 23 Favorites, 0 Comments

Trolley for Firewood Logs

Bringing firewood indoors always brings in a lot of dirt.

That's why I built two log trolleys that fit through the doors and are exactly the size of the firewood niche.

I built two of them so that the firewood can dry for one or two more weeks in the garage if it is a little damp.

The Base

To build the base of one unit you need:

  1. a 4 mm thick steel plate. The size may vary depending on your niche; mine is 750 mm x 490 mm.
  2. 6 square steel tubes: 30 mm x 30 mm x 100 mm (2 mm thick)
  3. 6 square steel tubes: 25 mm x 25 mm x 2 m (2 mm thick) (check that they fit inside the 100 mm tubes)
  4. 4 swivel casters (not fixed wheels; they rotate 360°)

Weld the 100 mm tubes onto the plate: one in the middle, the others 10 cm from the edges.

Drill holes to attach the wheels. Fix them with strong nuts and bolts.

The Bottom

The bottom is made of wood and has raised edges to keep dirt from falling on the floor.

Cut holes where the square tubes are.

Glue and fix small vertical boards between the holes.

The Rear

Add some boxes at the back, again to keep dirt and logs from falling behind.

I built them in several parts that fit into each other, so you can remove them one by one as the firewood level goes down.

You can use that space to store small branches for kindling.

The Top

Make a top with a wooden board and 6 steel angles.

The angles should fit into the tubes and hold them in place.

Fix some brackets at the top of your niche wall so that the tubes stay vertical when you remove the top.

Light the Fire!

No dirt, no fights with your wife ;-)

Light the fire and enjoy it!