TV Stand

by cgapay in Workshop > Furniture

33220 Views, 170 Favorites, 0 Comments

TV Stand

My parents had a tiny book shelf for their new TV so decided to build them a TV stand as a Christmas gift. The console took 3-4 weekends to build and cost around $200 in materials. The oak wood and light stain was chosen to match existing furniture. Dimensions: 65”w x 20”d x 27”h

Cut ¾” Plywood for Top and Bottom

Notch Corners to Fit Corner Posts With Edge to Meet Depth of 2x2 Corner Post

Glue and Finish Nail Edge Pieces to Top and Bottom

Reinforce Finished Edges to Top With Pocket Holes Using Kreg Jig

Braces Added for Hex Bolt Support to Corners. Countersunk Hole for Corner Screw.

Legs Attached With Bolt.

Process Repeated for Bottom Shelf With 2” Gap for Clearance Under Stand (bottom Being Held Up by Support Pieces in Pic As I Screwed in Corners.

Used Pocket Jig for Bottom Rather Than the Corner Bolts.

Aligning the corner bolts for the bottom was difficult so I opted for pocket screws instead.

Top and Bottom Finished.

Panels for Sides Measured, Cut and Secured With Pocket Jig Screws.

Divider Panels Cut and Secured With Pocket Jig Screws.

Slight Gap Left in Front to Allow for Oak Iron-on Veneer Facing.

Center Shelves Measured and Secured With Pocket Screws.

Support Brackets for the Shelves Cut and Screwed to Sides and Middle.

Shelves, Drawer Fronts and Back Cut

Left and right shelves cut and edged with finishing trim. Drawer fronts measured and cut to size of the openings. I opted for 2 drawers at the bottom and left the top open for a cable box and/or dvd player. I cut 3/4" plywood to size to fit the back openings and opted to leave the drawer slots open in the back. Back was inserted using pocket holes.

Drawers Measured and Notches Ripped for Bottom. Sides Were Taken in an Inch to Allow for Rails and Secured With Pocket Screws to Front.

¼” Panel Inserted for Bottom.

Drawer Back Screwed in to Finish.

Front Doors Measured and Cut With 45 Degree Angle. Door Frame Pieces Ripped and Notched to Allow for Plexiglass Insert.

Corners Glued and Screwed. Added Glue and “foot” on Corner to Add Support From Twisting. Cut and Sanded Off Foot.

No-mortise Hinges Attached.

Holes Cut in Back for Wire Access. 2 Coats of Light Honey Stain & 3 Coats of Matte Polyurethane.

Drawer Rails Attached.

Glue Attached to Inside Frame and Plexiglass Inserted and Clamped.

Magnet Attached.

Mirror Tacks Added for Additional Holding of Plexiglass.

Knobs Installed.

All Done!