Strider Camera Robot V6

by 陳亮 in Circuits > Robots

10704 Views, 148 Favorites, 0 Comments

Strider Camera Robot V6

This Instructables show how to build Strider Walker V6.

Supplies

  • TTGO T-Journal ESP32 Dev Board
  • OV2640 or OV3660 camera module with a little bit longer FPC
  • Two 4.3g servo with 360 degree rotation option
  • Two 801525 Lipo batteries
  • Two Paperclips
  • SMA Coaxial PCB mount Jack
  • A short SMA Antenna
  • Around 60-100 pieces of 4mm (actually 3.6mm) M1.2 screws



Paperclip Axis

  1. Straighten the paperclip and cut into 2 pieces
  2. Keep 24mm straight and belt remaining into a handle
  3. Repeat to make 4 paperclip axis

Servo Patch

Picture 1: 4.3g 360 servo

Picture 2: mark the cutting lines

Picture 3: unscrew the servo

Picture 4-5: cut the servo

Picture 6-7: screw up the trimmed servo

Picture 8: cut the original output axis

TTGO T-Journal Antenna Patch

Desoldering the TTGO T-Journal SMA edge mount Jack and replace with PCB mount jack.

3D Print

Please download and print all the parts at Thingiverse:

https://www.thingiverse.com/thing:5115055

Legs Assembly

Picture 1: leg1-4

Picture 2: connect leg2 and leg3 with screw

Picture 3: then connect to leg1

Picture 4: connect leg3 and leg4 with screw

Picture 5: repeat Picture 1-4 to assembly 1 more

Picture 6: connect leg2 and leg4 with screw

Picture 7: connect another leg2 and leg4 with screw

Repeat Picture 1-7 to assembly 6 pairs of legs.

Install Servo

Picture 1: servo and body

Picture 2: put the wire into the body hole

Picture 3: push servo into the body

Picture 4: screw up upper side

Picture 5: screw up with bottom

Install Crankshaft and Legs

Picture 1: install axis1 into servo axis

Picture 2: install pair of legs into axis1

Picture 3: install axis2

Picture 4: install next pair of legs into axis2

Picture 5: install next axis2

Picture 6: install last pair of legs into axis2

Picture 7: instal axis3

Install Paperclip Axis

align the leg1 and let the paperclip axis pass through the body and all the leg1.

Test Run

Use servo tester check all legs run smooth.

Install Another Side

Repeat steps 6-9 for the the side.

Connect 360 Servos

Screw up the T-Journal mount and body with 8 screws.

Cut the 360 servos wire and soldering to the TTGO T-Journal. Left side connect to GPIO 2, 3V3 and GND; Right side connect to GPIO 4, 3V3 and GND.

Install Battery

  1. Squeeze 2 Lipo batteries into the robot body front and back
  2. Screw up T-Journal mount, front and back with 4 screws
  3. Soldering 2 of them together in parallel connection to get a larger battery

Weight

Program

This instructables mainly describe the new version hardware assembly. Please refer to my previous instructables for the programming steps.

Note:

Please uncomment below line in camera_pins.h for this version:

#define CAMERA_MODEL_TTGO_T_JOURNAL_ROBOT

V2 Vs V6

Enjoy!