Spline Jig

by WesH31 in Workshop > Woodworking

88 Views, 0 Favorites, 0 Comments

Spline Jig

Gluing 45 degree angles for picture frames is not strong. You can add strength to the joints by adding a spline. This jig makes cutting the spline easy.

Cutting the Material

Cut the backboard 17 x 17 inches. The size can be adjusted larger or smaller depending on your table saw and needs. Measure the height of your table saw guide. Cut two pieces slightly wider that your guide height. Cut the lengths to 17 inches. Stand those two pieces on either side of your guide and measure from outside to outside. Add a little more (so this box slides over the guide easily) and cut that to width, again with a 17 inch length.

Making the Box

Set the height pieces back on either side of the guide, leaving a little play so that the box will slide easily over the guide. Place the top board on their top edges. Glue and screw it together.

Adding the Backboard

Place the backboard along one side of the box. Clamp, glue, and screw it together.

Adding the Picture Frame Supports

Measure to the middle of the backboard. Place the tip of a large square at the point. Using a speed square, put the arms of the large square at a 45 degree angle relative to the bottom of the backboard. Clamp it in place. Measure 2 inches up from the bottom. You could make that measurement higher or lower depending on the depth of the spline you usually cut.

Cut two pieces of 3/4 inch x 1 inch stock on a 45 degree angle. Place the 45 at the 2 inch mark and scribe a line where the stock runs past the edge of the backboard. For the 17 inch size, the long side of the support ended up at 9 inches. Make the other support board identical. Place them along the large square arms. Clamp them in place. Glue and screw.

Cutting the Spline

When the glue is dried, place the box over your table saw guide. Adjust the distance of the guide to the table saw blade so you picture frame will take the cut in the middle. Place a corner of your glued picture frame in the jig. Clamp it to the backboard, set the depth of your saw blade, and cut the corner spline. Repeat with the other corners.