Scary Talking Pumpkin

by LuigiS in Circuits > Arduino

654 Views, 5 Favorites, 0 Comments

Scary Talking Pumpkin

Halloween is creeping closer, and what’s more terrifying than a pumpkin that talks back? 🎃


Get ready for the ultimate spooky decoration: an easy-to-use, motion-activated pumpkin that plays eerie sounds and lights up with animated, glowing eyes!

Whenever movement is detected by the IR sensor, this scary pumpkin will randomly play from 1 to 5 spine-chilling sounds while its menacing red eyes come to life with haunting animations.

Perfect for scaring trick-or-treaters and creating a truly haunting atmosphere!

Supplies

  1. Plastic pumpkin
  2. Arduino Pro mini (or arduino nano)
  3. MP3-tf-16p
  4. IR sensor module
  5. Micro SD card, at least 1gb
  6. 2 x red LEDs
  7. 2 x 100ohm resistors
  8. Speaker 4/8 ohm
  9. 3.7 LiPo battery (you may use 2x AAA battery instead)
  10. Battery charger module
  11. Switch


TOOLS:


  1. Hot glue
  2. wires
  3. solder iron
  4. arduino pro mini programmer
  5. patience

Wiring

First, we need to connect the components as shown in the attached diagram.

Program Arduino

Next, we need to program the Arduino Super Mini using a specific programmer. I’m using a UART-USB programmer from Amazon (code attached).

Downloads

Assembly

Now it’s time to place all the components inside the empty pumpkin. Let your imagination run wild and create the scariest pumpkin ever!