Receiver Box PA 2200 RV

by Racing Victim in Workshop > 3D Printing

1606 Views, 7 Favorites, 0 Comments

Receiver Box PA 2200 RV

Designing a custom Receiver Box for my 1:8 scale RC car

Link to Shapeways

When you start to design your own components Use this code at Shapeways and get 15% off on your first print:

QKCTU

Photostream

Goals are:

- Lighter (Original 25.6 gram)
- Cheap (at least not more that original € 13,90)
- Easier Cable Routing
- Adding Programming Cable
- Adding ON/OFF Switch
- Fit Spektrum SR3520 Receiver

Achieved:

- 9.2 gram
- € 11,11
- Cable routing is easy in 3 layer box
- Easy access on ESC programming cable
- Switch added but flimsy support
- Receiver fits like intended

Know where your starting from

Avoid mistakes by integrating the environment

Make crazy designs because you can in 3D printing

Check if all components fit and get all possible functions integrated

Double check if all the functions work in the 3D environment

Challenge to make components better than original
In this case: Lighter, Cheaper and better Cable management