Race Car
This project is a RC car modified to can be controled by an microcontroller to can be drived by itself.
The scope of this project make the care able to run in a circuit bounded by reflective lines.
Materials
1: An old RC car.
2: Servo Motor.
3: DC motor.
3: Servo driver.
4: H-bridge to control the DC motor.
5: 4 x Line sensors
6: 12V battery for the motor (I use 9V + 2 * 1,5V).
7: 6V battery for the servo (I use 4 * 1,5V).
8. 5V battery for the arduino (I use a portable battery).
9. Microcontroller (I use Arduino Uno)
10. Some plastic gears to make the conections between the motors and the car's gear system.
11. Glue.
Construction
First of all you have to find a way to change the car's motors with your to be controled easier.
The back motor of the car can be used with the a H-bridge. I didn't use it because with the weight of the car with all the components, the motor didn't work. So I use a bigger one with a gearbox.
I use a servo to control better the direction of the wheels.
Wiring
We conecte the batteries to a switch and after to the components like this:
1: 12V battery -> H-bridge
2: 6V battery -> Servo
3: 5V battery -> arduino and to all the components that need the same Vcc Voltage to run (all the drivers)
4: Conecting all the signals cables to the microcontroller following the datasheet of the driver. From the h-bridge I use the enable and dir pins, from the servo the signal pin and from the sensor the output pins.
Software
For this project I use Arduino IDE with CPP code.
Code
Make functions that controls every driver separatly with one or more parameters.
Write functions that reads the sensors input.
1: setServo(Angle);
2: setMotor(Dir, Speed);
3: readSensors();
Until now I can control this functions with a joystick. The next step is to implement the algorithm that will make autonomous.