Pocket Launcher
The Pocket Launcher is a miniature sling shot designed to fit inside your pocket. While tiny, this item is robust and will be by your side through many adventures.
Supplies
- Scissors
- Measurement device
- 2 Rubber bands
- Felt
- Poms
- 3D printer
3D Print the Body
- Download .stl file
- Upload to slicer
- Print to desired settings
- Duration (1 hour)
Downloads
Use Scissors to Cut 2 Rubber Bands in Half
Cut a 30 MM X 100 MM Rectangle From Felt
Fold in Half
Fold Again "hotdog" Style for Added Strength
Use Scissors to Cut a Small Slit in Felt
- Cut a slit on the left and right side of felt
- Be careful not to cut too much
- Do not cut too close to the edge
Slip 1 End of Rubber Band Through the Slit in Felt
Tie the Rubber Band in a Knot and Trim Excess
Use Scissors to Cut a Sharp Angle on the Other End of Rubber Band
Poke the Tapered Rubber Band End Through Hole in Body
Tie Rubber Band in a Knot and Trim Excess With Scissors
- Repeat steps 6-11 to other side