Personal Weather Station Using Arduino UNO & DHT11 Sensor - IoT

by DebadriD in Circuits > Arduino

1293 Views, 8 Favorites, 0 Comments

Personal Weather Station Using Arduino UNO & DHT11 Sensor - IoT

A personal weather station using the Arduino Uno, DHT11 sensor and the ESP8266 module. The cloud platform used here is thingspeak.

The link to the weather stations is as follows:

https://thingspeak.com/channels/274868

Materials Required

1) Arduino UNO

2) DHT11 Sensor

3) ESP8266 Module

4) Breadboard and a few jumpers

Connections

1) Connect the ESP Module as per the diagram except for the Tx-Rx pin. Connect them to the pin nos. you've defined in your code. For ex. in my case it was 6,7'

2) DHT11 sensor O/P pin was connected to the A0 pin, and the other two pins to Vcc and GND.

That's it for the connection. Nothing more than that.

The Code

The code is very much understandable with comments mentioned beside the line of codes. The link is as follows:

https://github.com/debadridtt/Temp-Humid-IoT-Thingspeak/blob/master/dht11.ide/dht11.ide.ino