Pallet Shot Glass

by Maker2_0 in Workshop > Woodworking

1845 Views, 26 Favorites, 0 Comments

Pallet Shot Glass

This was a fun but long project and it made a mess, plus it was hard to find good pallet wood without knots or holes from nails.

Cut and Glue

I grabbed the smoothest and straightest board off the pallet and cut it into 3 good pieces to use. I used Titebond III to glue and it worked good, i used quick grip clamps and my vise to clamp it down since the boards were cupped.

Marking and Drilling

I removed the clamps and marked with a straight edge, an x that roughly helped me to find the center so I could punch it and drill it out. I then threaded in a woodworm screw for my chuck.

Securing the Blank

I put it in the chuck, brought up the tailstock, brought up my tool rest, tightened everything down, and I was ready to turn.

Setting Speed

Generally if your blank is square and about 1-2 inches you want to start at a slow speed like 1000- 1500 rpm.

Protection

Always... I don't have a respirator.

Tools

I used my roughing gouge and spinal gouge, I also used a scraper which is not shown here.

Roughing It

I used my roughing gouge to bring it into round and begins to shape it.

Shaping Your Blank

I used a pencil to mark my blank and than I parted it off.

Final Shaping and Drilling

I remounted the blank in my chuck and turned a taper towards the bottom. I marked with a pencil, the center so I can go to the drill press and remove most of the material in order to get my tool in the cup.

Hollowing It Out

I used my scraper to hollow it out and give it a smooth finish without sanding because that would be hard.

Sand in the Place Where You Live

I sanded and went up through the grits in order to get it smooth.

Remove the Tenon

I used the bandsaw to cut it off.

You're Done!

It looks cool and you can use it for other things beside drinking.