Optimized Soap Holder

by kxauvilea in Living > Cleaning

57 Views, 0 Favorites, 0 Comments

Optimized Soap Holder

Every day, my soap seemed to disappear faster and faster, whether I put it in the built in soap holder in the wall, or in a bag that could be hung on the wall. This project tries to optimize a soap holder for placement in areas that may accumulate a lot of water.

Supplies

I only used a Prusa mini printer for this project, and Fusion 360 to prototype!

1st Prototype

For my first prototype, I designed a container similar to traditional soap holders, but with a hole at the bottom to drain out water. The bottom of the container is also cone shaped, in an attempt to funnel water down towards the drainage hole.

3D Prototype 1

The prototype printed with errors, the hole covered with material, and I was unable to remove supports.

Improved Protoype

My 2nd prototype has a slanted bottom, more effectively shifting water towards the hole, and I adjusted the draining plate to be printed next to the container for easier removal.