Non-slip Socks Using Inner Tube

by AlexanderChenevert23 in Living > Life Hacks

646 Views, 0 Favorites, 0 Comments

Non-slip Socks Using Inner Tube

Everyone who has a smooth floor has slipped while in socks. If you make this you can stop this, and also stop some rubber from going to a landfill, where it will take the rubber hundreds of years to decompose.

Gather Matterials

You will need:

Inner tube

Scissors

Thread

Needle

Cut the Tube

Cut the valve off the tube. Cut the tune in half. Cut it again the long way to turn it into a strip.

Clean the Tube

There may be white powder on the inside of the tube. If o wash it off and dry off the tube.

Measure

You should cut a piece of the strip to match the length of the sock.

Preparing the Neadle

Thread the thread through the needle. Cut the string at 4 to 5 ft.(depending on how big the sock is). Take the two ends and tie a large knot.

Sewing Time

Sew through the tube and the sock. Go back through a bit further ahead. Go back a little bit. Repeat this until you get to the end.

Finishing It

Tie a big knot at the end, and cut off the excess.

What Is Should Look Like

The picture above show what your sock should look like.