Making a Cravat

by Jenn Nelson in Craft > Fashion

84439 Views, 38 Favorites, 0 Comments

Making a Cravat

Want a custom look for your groom and groomsmen for your wedding?  Need the right accessory for that steampunk outfit?  Make a cravat!

Materials

You will need from your fabric store:

1 yard fabric
scrap of interfacing
matching thread

You will need from your sewing box:
Sewing machine (or needle and lots of patience)
iron and ironing board
pins
scissors or shears

Buy or Make a Pattern

I used Butterick B4157 for the cutting pattern, but changed the assembly for a more formal, less costumey result.

The long "tie end" is 34" x 12".  The short "tie end" is 27" x 12".  The "collar" is 13 1/2" by 3", with a gentle curve.

For a Jabot (like a giant, floppy bow tie) make two long ends.  For a Cravat (tied with a Four-In-Hand knot,) make a long end and a short end.

Layout Your Fabric and Cut Your Pieces

Cut two tie ends, and two collars out of fabric.  Cut one collar out of interfacing.  

If you're lucky enough to have a padded cutting table, pin the pattern to the fabric to the table, and PUSH the scissors flat against the table while you cut.

Tie End

Fold tie end longways, right-side-together.

Pin the long edge and the slanty edge together.


Sew Tie End

Stitch a 1/4" seam along your pins.   Be sure to leave the short, straight end open.

Clip your corners.

Turn inside out.

Press (iron flat.)

Repeat with other tie end.

Collar

Layer fabric right-side-to-right-side and put interfacing on top. 

Pin together along long sides.

Stitch with 1/4" seam allowance. 


Finish Collar

Turn collar inside out.

Press.

Turn 1/2" of open end to the INSIDE to hide rough edge. 

Press flat.

Gather Tie Ends

Put a pin in each side of the open end of the tie end.  Wrap thread around one pin in a figure 8 pattern. 

Pull the other end of the thread until the open end is the same size as the collar opening.  Wrap the thread around the other pin in a figure 8 pattern.

Press.

Stitch 1/4" from the edge.

Final Assembly

Remove pins.

Insert tie end into open end of collar.  Pin in place.

Stitch close to edge.

Tie One On!

For a jabot, make a loose, floppy bow.

For a cravat, tie in a four-in-hand knot like a regular necktie.

Tuck under collar, and wear proudly!

Now make some vests to match!

https://www.instructables.com/id/Sewing-a-mens-formal-vest/