Led Cork Man

by TangoT1 in Circuits > Electronics

1352 Views, 6 Favorites, 0 Comments

Led Cork Man

Hi

in this instructable i will be teaching you how to make a small led cork and wire man.this is a great project to do when you are board or ifyou just want a small little project to do on the week-end.It is very good because it is recycling some materials and it is only using a couple of parts which are easy to find an easy to use.

Materials and Tools

wire

pliers

cork

2 leds

1 3v battery

Cuting Some Wire

cutt a small spike at one end of the wire to stick into the cork.

90 Degree Bend

stabb the wire into the cork and make a 90 degree bend.

Shape

bend into a small stick man as shown in the picture above and then stick the other end into the head/cork.

Head

pull the head of the body. mark the eyes

Middle Head Hole

drill a hole throught the middle up the the head till you reach the eye markings.

Drill the Eyes

drill the eys at a high angle toward the bottom of the head untill you reach the hole in the middle of the head.

Wiring Leds and Finalproduct

push the leds into the eye sockets and wire them up to a power supply after glueing the body back on to the cork.