Kids Rocking Chair

by CrazyCosplayLady in Living > Kids

1031 Views, 5 Favorites, 0 Comments

Kids Rocking Chair

Made A kid's Chair with my dad for my 4 foot brother :) it's not a laid back rocker, because we designed it to make it easier for him since he can't sit still.

Plans

We drew out a basic idea of what we wanted, but we kept it simple because we were aware we would need to tweak it later on.

Shopping!

We purchased

2: 2x4" x 8ft boards

2: 1x4" x 10ft boards

1: 1/2" 4x4ft plywood

Cut!

Time to cut the boards! Our seat was decided at about 16 inches wide.

So we marked and cut everyone of our boards at 16 inches, and checked their heights and matched them.

Measure Your Kid and Make Adjustments!

Our original measurements were off, so it was time to improvise!

He just laid on the wood while we sketched it out!

Cut Out Sides!

We cut out our measured side

Sanded the rough edges

Flipped it and traced it on the wood

Cut and sand the second side

Sand and Paint the Slats/boards

We used an electric handheld sander to do a quick rundown over the slats to smooth them down.

We then painted three sides of the wooded boards. These will be the bottom and sides of each slat.

Paint Both Sides!

We went ahead and painted both sides of both sides! We used Black Gloss Rustoleum for all of the wood!

Staple and Screw Boards to Sides!

We went ahead and stapled the slats first, while we got an idea of placement, and to keep them steady for the screws.

Wood Putty

Here we filled in all of the screw holes with wood putty!

Testing Time!

We had him try it out, and he absolutely loved it!

Sand by Hand

Here we gently sanded down the wood putty with a piece of sand paper to smooth it out!

Repaint!

We repainted the sides of our wood, but our slats only needed one coat!

The Finale!!