Interchangeable Stamp

I made a stamp that can swap out different designs. This will help save space.

1. Black 3D Printing Filament
2. TinkerCAD

Size the block to a little bigger than the size you want your stamp.

Make another block the size of the stamp you want use it as a hole to cut out the indent for the stamp.

On TinkerCAD. Get three cylinders with all the same radius. Make two the same length and one about 6 times as long. Then get a circle, cut it so that one part is facing down and the other part is laying horizontal. Copy the part of the circle and place one on top of one small cylinder and the other on the other small cylinder. Put the long cylinder in between laying horizontal. Add this handle on to the top of your stamp block laying longways.

Copy one of the small cylinders in TinkeCAD and make it a hole and put it on one side of the block, copy that and put it on the other and make sure that it goes all the way through to the other side. Make a peg a little smaller than the holes you just created. Put a small square on top and copy the complete piece you just made.

When you made the hole for the sizes of the stamp, make a block that is 0.05 mm smaller on each side except the top and bottom. And then you can add a design to the block to make a stamp. Repeat with different designs.

You can use the pegs to get the stamp out by placing the pegs in one of the holes on the case and push to remove the stamp. Replace when needed.