Getting Started With Arduino : Blink

by Michael-John-123987 in Circuits > Arduino

885 Views, 11 Favorites, 0 Comments

Getting Started With Arduino : Blink

Hello everyone, Welcome to my first instructable.

In this instructable we'll be learning how to program an Arduino UNO to blink a LED.

Parts

For, Blinking a LED with arduino we'll need:

  • An Arduino
  • A LED
  • A 220 ohm resistor
  • Some jumper or hookup wires

Wiring

Hookup all the components according to the circuit diagram shown above.

Now, why we need a 220 ohm resistor in the circuit above?

The ordinary LED operates on Low current values than what a arduino gives.

So, In order to limit current through the LED we add a 220 ohm resistor in series with the LED to increase the overall resistance and to decrease value of current through the LED to prevent it from burning.

Upload the Sketch

Start the Arduino IDE

And, load the 'Blink' sketch that you will find in Arduino IDE under File > Examples > 01.Basics > Blink

Or, copy it from below:

// the setup function runs once when you press reset or power the board

void setup() {

pinMode(13, OUTPUT); // initialize digital pin 13 as an output.

}

// the loop function runs over and over again forever

void loop()

{

digitalWrite(13, HIGH); // turn the LED on(HIGH is the voltage level)

delay(1000); // wait for a second

digitalWrite(13, LOW); // turn the LED off by making the voltage LOW

delay(1000); // wait for a second

}

Then, click on upload.

Done

Once the uploading process completes you could see your LED blinking.

What next?

Now, all you need is to play with the program.

  • Try changing the parameter in 'delay()'. For instance, Try 100 or so to Blink your led at a faster rate.
  • Try using multiple led like 2 or 3.

Thanks for viewing.

Please write your questions or suggestions below.