Foam Board Volcano

by Herex1 in Circuits > Electronics

513 Views, 1 Favorites, 0 Comments

Foam Board Volcano

Be advised that I am using the best supply available to me you may have better supplies depending on where you are from

Supplies

(1)foam board (pink foam most preferred)
(2)knife
(3)wire
(4)red tape (transparent)
(5)light (red or orange light most preferred)
(6)paint(red,black or brown) and brush
(7) batteries
(8)glue or sticks

Cut Foam Board Into Shapes

The shapes should resemble that of mountain ..for ease I cut 3 circle of different diameter and cut terrain in them

Cut Hole Into Foam Board

Cut through holes through two of the circle foam board and cut away parts of the third such that it looks like a plate

Paint

I used a black paint here

Fit Light Into the Plate Board

Cover the Plate Foam Inner With Red Tape

Select Another Foam Part and Poke Light Covered in Red Tape Through It

Set the Pcs of Foam Board One Over Another and Join the Wire Connected to the Light in Series

Connect the Wires to the Battery and Light It Up

Hold Down the Layers of Foam With Either Glue(do Not Use Super Glue) or Just Poke Long Sticks Through It