Null
The fidgetCHARGE is a revolutionary new way to use your fidget spinner. To make it, print out the STL file. Materials needed to make: Copper wire (thin), 7mm circular magnets (x2), a phone charger (works best on android devices). Steps: 1) First, print out the STL file. 2) Then, coil the copper wire around both caps towards the middle ring. 3) Next, hot glue the magnets to the inside of the toruses on both sides. 4) Next, cut the insulation of the charger wire 1.5 inches. 5) Finally, solder the copper wire tips of the coil attached to the caps to the ends of the phone charger wire.