Dango

Welcome to my instructible cutesy creation 3D creation

A 3D printer and filament.

Step 1: I revolve around a center line, and for the rounded objects I did a spline and 3 point arc for the shapes of the creation.

Step 2: Next, I wanted there to be a stick on them so I did another revolve around the center line, and used a dimension of 1.50 for the width of it.

Step 3: I next did some cat ears for the first face, and I used the spline tool to make the shape of the ear and when I was done I did an extrusion to make it and I did a fillet with the radius of 0.9 inches so that the ear wouldn’t look so pointy.

Step 4: Then I drew the first face pieces to the top cute thing, and extruded it and after I used a revolve cut to make it look good instead of it just popping out.

Step 5: After making the first face I started working on the middle one on the front plane using the same step that I used to make the first face.

Step 6: Finally, after doing all of the steps you should get to the last face and what I did was I sketched out the glasses and mouth, the glasses were .6 inches wide and the mouth 0.8 inches using the 3 point arc, and after that I extruded it and revolved cut it so that it wouldn't just be straight out.