DRONE X5

by jimcartin in Circuits > Remote Control

38551 Views, 141 Favorites, 0 Comments

DRONE X5

the idea of ​​these instructions is to create a platform-based DRONE flying wing X5, here is specifying the instructions and materials needed to carry the project to a successful conclusion, this drone x5 will have as main ojetivo the ability to carry a camera photograph and make mapping.

 

 

The Parts Needed to Build the X5 DRONE

The Parts Needed to Build the X5 DRONE

2- Autopilot APM 2.5 with  GPS

http://store.3drobotics.com/products/apm-2-5-kit

The Parts Needed to Build the X5 DRONE

The Parts Needed to Build the X5 DRONE

The Parts Needed to Build the X5 DRONE

The Parts Needed to Build the X5 DRONE

6- Radio with more than 6 channels.
radio options there are many options on the market, I specifically use Futaba 12FG

The Parts Needed to Build the X5 DRONE

7-Propeller apc 9x6

Configuration Instructions

1- download the last file Mission Planner
https://code.google.com/p/ardupilot-mega/downloads/list



Configuration Instructions

2- install mission planner
This presentation should be installed and executed after



Configuration Instructions

3- connect APM 2.5  to PC.

Configuration Instructions

4- install the latest firmware on the APM 2.5
The following image shows the specific values ​​of the PID for the wing X5 for firmware 2.71


Configuration Instructions

5- set your radio to the option to fly wing.

a- elevator exponential  -30
b- aileron exponential    -20


Configuration Instructions

6- adjusting the movement of the servo as shown below. 13 mm up and down

Configuration Instructions

the entire assembly

Flight Test