DIY PCB Making for RGB LED

I made DIY PCB at home for RGB LED. Please Watch this video for Better Explanation.

I printed PCB layout on Photo Paper using Laser Printer. (Laser Printer Must)
PCB Layout For RGB Controller http://bit.ly/2X0Dk43

I used 12" x 12" copper clad Board

Cutting PCB Layout and Copper clad board

For Ink Impression i used Electric Iron

I pressed Iron For 5 to 6 minutes

After Pressing Done Remove Photopaper from copper Board very slowly.

I made Etching solution by FeCl3 Powder and Water.

Sink the board into Etching Solution for 15 minutes.

After removing Extra copper, wash the board with fresh water.

After Cleaning PCB, My pcb looks like this.

Drilling for components as marked.

Components:
IRFZ44N Mosfet x3
2.2uf 63v Capacitor x3
1M Resistor x3

Solder Components as Showing.

Adding Female Header For RGB Strips Power Out.

Solder Power Wire as Showing (12V power Supply)

Lets Power up the circuit with 12v power supply. and Plug RGB strips in the Female Header

Done.
RGB Circuit Runs Good.