DIY Cherry & Maple Coasters

by simplecove in Workshop > Woodworking

5626 Views, 101 Favorites, 0 Comments

DIY Cherry & Maple Coasters

These cherry and maple coasters are a fun weekend project that allows you to use up some of that scrap you have laying around. They are 3 3/4 inches squared and 1/2 inch thick including the cork on the bottom.

Prepare Your Lumber

I milled the cherry and maple to 3/8 inches thick at the planer, ripped them to 4 inches wide at the table saw and then cut them to 16 inches in length. Back at the table saw I made the following rips:

Cherry:

1 1/2 inch strips (QTY: 2)

1/4 inch strips (QTY:1)

Maple:

1/4 inch strips (QTY: 5. Only needed 4 but was good to have an extra just in case)

Glue Up!

Glue up the boards in the following order:

Cherry (1 1/2"), Maple(1/4"), Cherry(1/4"), Maple(1/4"), Cherry(1 1/2")

Cut to Final Dimension

Using my cross cut sled, I cut the coasters to 3 3/4". You should get a total of 4 coasters from the 16" glue up.

Drill Hole for Cork

These coasters will have cork on the bottom and on the top. But the cork on the top will be recessed in a 2 3/4" hole. Over at the drill press I used a 2 3/4" forstner bit and drilled a hole the same thickness as the cork in the center of each of the coasters.

Add Cork on the Bottom of the Coasters

Using regular wood glue, I glue cork to the bottom of the coasters.

Pre-finish the Coasters

Before I add the coasters to the top, I cut out some painters tape and fill the holes to allow me to pre-finish the coasters without getting finish in the glue area.

Add Cork to the Top

Using a circle cutter, I cut out 2 3/4" cork circles and glue them in the recessed holes using regular wood glue.