Cute Ghost

I made a 3D model of a Cute Ghost because I thought it was a good idea for somthing cute for the spooky season. I thought it matched well with this seasons theme.

Sketch the body of your ghost add the measurements. Makes sure to only add half of the body on the centerline on the origin. This will make sure you are able to revolve your sketch.

Then use the revolve tool on your sketch along the centerline that is located on the origin. This creates the 3D effect and turns your simple sketch into the body of a ghost.

Go to the top plane, add a horizontal centerline and sketch a half circle, make sure it is on the midpoint. Then you can use the circular pattern tool to copy it around the circumfrence of the base of your ghost. You later will use a extruded cut this to create the fold of the ghost's blanket.

On the same plane create a new sketch, use a arc and the convert entites tool to round off the front of each leg. Then you will cut it off and it will give your ghost even more detail. To copy it to other leg use a circular pattern to put around.

Create a new sketch on the front plane and draw the eyes using the circle tool and give it a measurement, add a horizonrtal centerline and make sure the eyes are allined perfectly. After you will extrude the eyes out and wrap it to your ghost's body. You do this using using the wrap tool.

On the same plane draw the mouth as a half circle using the line tool and the arc tool. Now and your measurements and repeat the steps from the last step. Extrude it then use the wrap to add to your ghost.

Now create a new front plane sketch, start on the right side of the ghost and give it the measurements. Make sure to add a vertical centerline going through the middle of the ghost. After use the centerline to mirror about using the mirror tool to add the other side of the arm.

After, you extrude the arms using a midplane extrude. This will make the arms 3D so you can later fillet them and make them smooth.

Then using the fillet tool make the arm smooth and round. Make sure to click on all the edges that the arms has so it is nice and smooth.

Now on the right plane of the ghost create a new sketch and draw a rectangle under the arm. Add the measurements to the rectangle. This is so it makes the blanket on the ghost look better.

You now can extrude your rectangle with a midplane untill it touches both arms. You will later cut the rectangle on both side and make it look like a blanket.

Now start a front plane sketch and using the convert entities tool and arc tool. Make it so the edges of the rectangle look like wings on the ghost. Now you can use the cut extrude tool to get rid of the edges.

Lastly use the fillet tool to smooth of the under part of the arms. Add the measurements and makes to click every single sharp edge.