Combi Square Holder
Ive been re fitting my workshop / shed, and a big part of what i needed was proper tool storage.
I dont own that many tools so i decided to hand all of my most used / important tools above my workbench.
So heres a quick look at how i made a combination square holder.
Hope you like it.
Please leave a like, share & comment. And subscribe for more like this!
Check out the build - https://www.youtube.com/channel/UCRMjvilGRdZxHqr34QKzB_Q
Follow my work on Instagram - https://www.instagram.com/ggwoodprojects/
Help me make more projects - https://www.patreon.com/GGWoodwork
OR
One time tip - https://www.paypal.me/GGwoodwork
Thanks
GG
Layout
As with pretty much everything i was using scraps here, but it worked out well because i only needed small bits.
I started by cutting a base piece to the match the base of the square, then two smaller pieces which i inlay'ed into the front to stop the square falling forward.
Glue Up
One everything was cut to the right size i glued the front pieces in and made sure the base of the square would fit snugly between the front and the tool wall.
Attaching
The same process as with the bevel gague, i wanted it to be "floating" so i drilled some holes for small nails on both the holder and the tool wall and used the nails as dowels. I mainly did this because the piece was so small there was no way i could use proper dowels but i wanted it to be "floating"
So there it is nice and easy.
Hope you like it.
Please leave a like, share & comment. And subscribe for more like this!
Check out the build - https://www.youtube.com/channel/UCRMjvilGRdZxHqr3...
Follow my work on Instagram - https://www.instagram.com/ggwoodprojects/
Help me make more projects- https://www.patreon.com/GGWoodwork
OR
One time tip - https://www.paypal.me/GGwoodwork
Thanks
GG