Cheap Selfie Light

by jagabardeen in Circuits > LEDs

276 Views, 0 Favorites, 0 Comments

Cheap Selfie Light

How to make cheap Selfie light from 20 W Tubelight

Supplies

1. Soldering Iron

2. Fevi-quick

3. Plastic

4. Hacksaw blade

5. Wires for joining

6. Double-side Stickers

7.Plier

Take 20W Tubelight With Measuring Tape

First Take 20W Tubelight and Measuring Tape

Measure the Length in Cms

Measure Tubelight in Cms. Here my tubelight length is 118 cms

Now Divide into 4 pieces ,Mark in Tubelight with Marker

=118/4

= 29.5 cms

Remove Side Protective Cover

Use screw driver and gentle push the nob

the Side cover fall off.

Use same technique in opposite side too.

Desoldering the LED Wire

Caution: Remove the Plug and wait for 10min until all current in capacitor looses.

Now Desoldering + terminal and - terminal of LED strip.

Remove Top Cover and Inner Circuit

Slide of Top cover and separate from base.

then pull LED + wire and get the circuit.

keep it separate for final sodering

Cut Down

1. Cut down both bottom holder and top protective Plastic into 29.5 cms

2. Scrub the LED strip and make sure Copper easily visible from all 4 pieces.

3. use wires and soldering the wires similar to original layout.

4. soldering both ends

5. Add LED driver circuit solder + LED terminal and - Led terminal similar like original Wiring

Final Arrangement

1. After careful soldering of all 4 pieces.

2. arrange like rectangle.

3. use Fevi-quick and paste backside some plastic for support.

4. use 45 degree L angle plastic for support all 4 corners inside of Selfie light.

Final Test: Selfie Photo Taken With Room Light

Photo Taken With DIY Selfie Light