Athens Georgia Wire Map

by jbr55011 in Workshop > Laser Cutting

534 Views, 0 Favorites, 0 Comments

Athens Georgia Wire Map

This is decoration is a road map of Athens, Georgia. The main Roads are laser cut into the wood. There are 3/4" nails hammered into each intersection. The wire represents the roads.

Supplies

3/4" Nails

10/16" Thick Wood Board of Choice (Can Be Thicker)

Metal Wire

Hammer

2 small screws

Drill

Laser Cutter

Jigsaw

Band saw

Sand Paper

CAD/Sketch Design

Use a reference photo of a map of Athens. Use it to Cad Lines over each of the main roads as well as to cut the shape of Athens out.

Measure Wood and Cut

Measure out Rectangle approximately the size you would like the decoration. Use a jigsaw to cut out the rectangle.

Laser Cut Design Into Wood

Upload an file that includes the sketch lines into the program you run your laser cutter on. (optional: In the program put "Athens" in one of the spaces).

Cut Out Shape

First use a Jigsaw to cut most of the access off.

Then use a band saw to get more exact lines closer to the shape

Finally Sand down the edges, make sure the edges are smooth.

Hammer Nails

Hammer in 3/4" Nails at each intersection where roads meet, but make sure not to hammer through the board.

Connect Intersections With Wire

Connect each intersection with wire over the road lines. Each wire represents a main road. Start by twisting one end to a nail, then pull the wire coil to the next nail, twist then cut. PLIERS ARE RECOMMENDED.

Install Hanger

Drill two Screws in the back of the decoration. Make sure not to drill through the board. Connect the two screws by wire.

FINISHED PRODUCT

At this stage the product is finished. (Optional: Stain the wood before hammering nails in)