Arduino Security Alarm
Hi, this is my new arduino security alarm project. I made it with simple materials. An ultra sonic sensor, a led,buzzer,breadboard and my arduino. IF any object move there, the will glow and the buzzer starts beeping.This helps from robbery.This always alert you and little useful in our life.
Materials Required:
1.An arduino board
2.a Breadboard
3.an ultrasonic sensor(HC-SR04)
4.a Led
5.a buzzer
6.Jumper cables
Connect the Ultrasonic Sensor to the Breadboard:
connect the trigger pin to the digital pin 13
connect the eco pin to the digital pin 12
connect vcc to 5v
connect the gnd to the gnd pin
Connect the LED and the Buzzer :
connect the cathode of the led to the anode of the buzzer,so you get one +ve and one -ve.
connect the +ve ends of those to the digital pin 10.
connect the -ve ends of those to the digital pin gnd
so you get the led and buzzer to be triggered.
Coding......
copy and paste the code to your IDE:(dont worry about the led1)
#define trigPin 13
#define echoPin 12
#define led 11
#define led2 10
void setup() {
Serial.begin (9600);
pinMode(trigPin, OUTPUT);
pinMode(echoPin, INPUT);
pinMode(led, OUTPUT);
pinMode(led2, OUTPUT); }
void loop()
{ long duration, distance;
digitalWrite(trigPin, LOW);
// Added this line delayMicroseconds(2);
// Added this line digitalWrite(trigPin, HIGH);
// delayMicroseconds(1000);
- Removed this line delayMicroseconds(10);
// Added this line digitalWrite(trigPin, LOW);
duration = pulseIn(echoPin, HIGH);
distance = (duration/2) / 29.1;
if (distance < 4) { // This is where the LED On/Off happens digitalWrite(led,HIGH); // When the Red condition is met, the Green LED should turn off digitalWrite(led2,LOW); } }