Arduino Nano Motor and Pump

by devkrishnavhora in Circuits > Arduino

77 Views, 0 Favorites, 0 Comments

Arduino Nano Motor and Pump

Objective

The objective of this project is to control a motor and water pump using an Arduino Nano.

A 16×2 LCD is used to display the current status of the motor and pump. A push button connected to D12 is used to turn the motor and pump ON or OFF.

The motor and pump are controlled through their respective motor-driver connections.

Supplies

Arduino Nano

DESHBOT Shield

16×2 LCD

Push button

Motor

Water pump

Pin Connections


16×2 LCD

The LCD uses the DESHBOT Shield pin configuration:

LCD ConnectionArduino Nano

RS - A4

EN - A3

D4 - A2

D5 - A1

D6 - A0

D7 - D13

These are the LCD connections used in the supplied project code.

Control Button

ComponentArduino Pin

ON/OFF Button - D12

The button uses INPUT_PULLUP, so one side of the button is connected to D12 and the other side is connected to GND.

Motor

Motor DriverArduino Nano

Motor A - D6

Motor B - D7

Pump

Pump DriverArduino Nano

Pump A - D8

Pump B - D9




Working Principle


When the Arduino Nano is switched ON, the LCD displays:

DESHBOT MOTOR
PUMP CONTROL

After the startup message, the LCD displays the current motor and pump status.

Initially, both the motor and pump are OFF.

The LCD displays:

MOTOR + PUMP
OFF D12 = ON

When the user presses the D12 button, the Arduino turns ON both the motor and pump.

The LCD changes to:

MOTOR + PUMP
ON D12 = OFF

When D12 is pressed again, both the motor and pump are turned OFF.


Motor Control

The motor is controlled using two Arduino pins:

  1. D6 = Motor A
  2. D7 = Motor B

When the motor is turned ON:

D6 = HIGH
D7 = LOW

When the motor is turned OFF:

D6 = LOW
D7 = LOW

The motor should be connected through a suitable motor driver rather than directly to the Arduino Nano.


Pump Control

The pump is controlled using:

  1. D8 = Pump A
  2. D9 = Pump B

When the pump is turned ON:

D8 = HIGH
D9 = LOW

When the pump is turned OFF:

D8 = LOW
D9 = LOW

The pump should use an appropriate driver and external power supply according to the pump's requirements.


Button Operation

Only one button is required in this project.

D12 works as the ON/OFF control.

First Press

Motor → ON
Pump → ON

LCD:

MOTOR + PUMP
ON D12 = OFF

Second Press

Motor → OFF
Pump → OFF

LCD:

MOTOR + PUMP
OFF D12 = ON

The same process can be repeated continuously.


LCD Display

The 16×2 LCD provides information to the user.

Startup:

DESHBOT MOTOR
PUMP CONTROL

When OFF:

MOTOR + PUMP
OFF D12 = ON

When ON:

MOTOR + PUMP
ON D12 = OFF

This allows the user to easily understand the current state of the system.

Downloads

Conclusion


The DESHBOT Motor and Pump Control System is a simple Arduino Nano project that demonstrates how external motors and pumps can be controlled using a microcontroller.

The 16×2 LCD displays the system status, while the D12 push button provides simple ON/OFF control.

When D12 is pressed, the Arduino activates both the motor and pump. Pressing D12 again stops both devices.

The project provides a basic foundation for developing more advanced systems such as automatic water pumps, irrigation systems, cooling systems, and IoT-based pump controllers.